Troubleshooting Trailer Lighting that Isn't Grounding Through Aluminum Fender
Question:
Son took off fenders and side lights because of a weight issue. Now I am putting them back on. I have no light now. All worked before this. Aluminun fenders were grounded with light before and now. Kids. Enclosed forester 6x12 trail or . Van electric good works. Help!
asked by: Diana
0
Expert Reply:
Since the fender is aluminum and aluminum does not conduct electricity well you are going to need to run a jumper wire from the ground circuit to the main ground harness of the trailer or if the trailer frame is steel you could run it directly there.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
LED Combination Tail Light Kit for Trailers under 80" Wide - Submersible - Driver and Passenger
- Trailer Lights
- Tail Lights
- License Plate
- Rear Reflector
- Side Reflector
- Stop/Turn/Tail
- Square
- Kit
- Surface Mount
- Submersible Lights
- LED Light
- 5L x 5W Inch
- Red
- Optronics
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Most Popular Wheel Bearings
- Article: Trailer Tire Sizing
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Lighting Requirements
- Q&A: What Are the Overall Dimensions of the Optronics Under 80-Inch LED Trailer Light Kit # TLL9RK
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: How Does the Submersible, Under 80" LED Trailer Light Kit part # TLL9RK Wire to Trailer
- Q&A: 2015 Lincoln Navigator Brake Controller Wiring Harness Connection Location
- Q&A: Is Demco SBS Coach Air Kit SM99627 The Same as Demco 6231
- Q&A: Are the Waterproof, Under 80 inch LED Trailer Lights TLL9RK Completely Sealed
- Q&A: How To Wire In The Lippert Replacement Hydraulic Power Unit Part # LC141111
- Q&A: Tire and Wheel Combinations Balanced From The Factory