Mounting Bolt Sizes for the Rack'em Double Barrel Utility Trailer Tailgate Lift Assist
Question:
What size bolts are used to install the racket double barrel ra27-c. Are they 1/2” x 2” for the unit and 3/8” for the power plate. And how close should the main unit be to the back gate? Is there a specific gap onrail between the unit and back gate?
asked by: Randal
Expert Reply:
The larger bolt for the Rack'em Double Barrel Utility Trailer Tailgate Lift Assist # RA-27C is a 7/16" (almost M12) with 14 TPI (threads per inch) while the smaller bolt that holds the pate for the gate is 5/16" with 24 TPI.
According to the instructions you want to get the main unit as close to the gate as possible without interfering with the gate latch (see attached photo from the instructions).
Attached is a review video that you can check out as well.
Product Page this Question was Asked From
Rack'Em Double Barrel Utility Trailer Tailgate Lift Assist w/ Chain - 200 lbs
- Lift Supports
- Trailer
- Tailgate Assist
- Steel
- RackEm
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How to Make Raising and Lowering a Heavy Trailer Ramp Easier
- Q&A: Ramp Assist Recommendation for a 60 lb Ramp
- Q&A: Alternate Mounting For Rackem Double Barrel tailgate Assist On Trailer With 3 Foot Sides
- Q&A: How Can Double Barrel Trailer Tailgate Assist # RA27C be Mounted on 24 inch Tall Trailer Side Rails
- Q&A: Hub And Drum Replacement for 90865 Rockwell Hub and Drum
- Q&A: Recommended Gate/Ramp Assist and Hinge for Trailer Build
- Q&A: How to Adjust Assist Tension on the Gorilla Lift Tailgate Assist
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Measure a Trailer Axle
- Article: Slipper Spring Trailer Suspension System Review
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)