What Size Hole Do I Need To Drill To Run the Wire for the LED Light Strip Kit
Question:
what size would I need to drill through my camper exterior wall to run the wiring inside? It looks like the ends are pre-installed on the wiring.
asked by: Robert A
Helpful Expert Reply:
I went out to our warehouse for you and measured the connector that attaches to the end of the LED light strip on the LED Light Strip Kit with Wireless IR Remote part # DG52688. This connector is just under 1/2" at it widest point so you will need to drill a 1/2" diameter hole into the exterior of your trailer in order to run the connector through. In order to prevent any sharp edges on the trailer's exterior walls from piercing the jacket on the above wire you will want to use a grommet in the hole part # SWC8075-1.
The ends of the harness that run to the light strip from the control box are plug and play and so is the rest of the kit save for the 12 volt power connection (if used).
Products Referenced in This Question
Open Snap Bushing - 1/2" Diameter Mounting Hole - Qty 1
- Wiring
- Wiring Protection
- Bushing Grommet
- 1/2 Inch Diameter
- Spectro
more information >
Continue Researching
- Shop: Trailer Hitch
- Shop: Open Snap Bushing - 1/2" Diameter Mounting Hole - Qty 1
- Shop: Draw-Tite Drawbar for 1-1/4" Hitches - 3-1/8" Rise - 9-3/4" Long - 3,500 lbs
- Shop: Trailer Wiring
- Shop: Vehicle Tow Bar Wiring
- Video: Curt Hitch Ball - Trailer Hitch Ball - C40018 Review
- Video: Tekonsha T-One Vehicle Wiring Harness Installation - 2011 Nissan Juke
- Video: Tekonsha Custom Fit Vehicle Wiring - Trailer Hitch Wiring - 118528 Review
- Video: Tow Ready 4-Pole Mounting Bracket Installation
- Search Results: wiring
- Search Results: tekonsha
- Search Results: 18140
- Search Results: wiring protection
- Search Results: receiver
- Shop: T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Shop: Mounting Bracket 4-Pole Flat
- Shop: 2" Hitch Ball - 3/4" Diameter x 2-1/8" Long Shank - Chrome - 3,500 lbs
- Shop: Roadmaster 4-Diode Universal Wiring Kit for Towed Vehicles - 7-Way to 6-Wire Hybrid Cord
- Search Results: 36065
- Search Results: foam gasket
- Shop: Brake Controller
- Video: Spectro Wiring SWC8075-1 Review
- Video: etrailer Stabilizer Jacks Review