2010 Reliable Trailer Shock Damper Replacement
Question:
I have a shock damper that needs to be replaced, measurements are from center hole to center hole. Measured roughly compressed 5 7/8 and not compressed it is roughly 7 3/4. The closet one i have found is the titan/dico Model 10 and 6, is this accurate? Also I dont remember each side having a different hole diameter, it did have plastic sleeve s, are there different sleeve diameters that I can purchase to match my bolt? Thanks
asked by: Jaron
Expert Reply:
One of our replacement shocks might work for your Reliable actuator but we do not carry that particular brand so you would have to go by the measurements.
Replacement Shock for Titan Model 6 and 10 Brake Actuators # T1242600 measures 6 inches retracted and 8-1/16 inches extended. I believe this would be your best option.
Product Page this Question was Asked From
Replacement Shock for Dexter Model 6 and 10 Brake Actuators
- Accessories and Parts
- Brake Actuator
- Disc Brakes
- Hydraulic Drum Brakes
- Shocks
- Dexter
more information >
Continue Researching
- Q&A: Replacement for Gabriel Shock Model 610712
- Article: How to Measure a Trailer Axle
- Q&A: What is Amperage Draw of Lippert Ground Control Leveling System # LC358590
- Q&A: Recommended Replacement For A JVR9000R RV Stereo System With Three Cameras
- Q&A: Taillight Converter Needed To Separate Brake Lamp and Turn Signal Circuits
- Q&A: Option to Replace Jensen JRV9000R
- Q&A: How To Convert A Wishbone Trailer Wiring Harness To A Regular 4-Flat Trailer Wiring Harness
- Q&A: 40' Wishbone Trailer Wiring With A Ground Wire Running Down Both Sides
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Hand Winches
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs