How Long of Frame Channel is Needed to Install Titan Model 6 Actuator
Question:
I have to grind off old actuator and sway bartto install the new one I bought from you. length of 3 tube required on trailer to install Mdl 6 Titan actuator Thx
asked by: Robert G
0
Expert Reply:
The mounting flange length of the Titan Model 6 actuators is 9-1/2 inches and the additional length the master cylinder adds to that is 6 inches so you'd want to have around 16 inches of frame channel to install a Titan Model 6 actuator like the part # T4079200 that you referenced.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Dexter Zinc-Plated Brake Actuator - Drum - 2-5/16" Ball - Bolt On - 8,000 lbs
- Brake Actuator
- Surge Brake Actuator
- Agricultural
- Construction
- Marine
- Travel Trailer
- Utility Trailer
- Bolt-On
- 8000 lbs GTW
- 2-5/16 Inch Ball Coupler
- Drum Brakes
- No Lockout
- Dexter
more information >
Continue Researching
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Difference Between Model 60 Surge Trailer Brake Actuators that Fit Disc and Drum Brakes
- Q&A: Difference Between Single, Dual and Free Backing Servo Brake Assemblies
- Q&A: Replacement Trailer Coupler to Replace Dico # 17550
- Q&A: How To Determine the Weight Capacity For a Trailer Axle
- Q&A: Galvanized Surge Brake Actuator and Brake Assembly for a 3,500 lb Axle
- Q&A: 3,500 lbs. Axle with Hydraulic Drum Brakes Kit
- Q&A: How To Determine Axle Diameter And Size
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Best Winch for You, your Boat, and your Trailer
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Raise Your Travel Trailer Height
- Article: How to Accurately Measure Trailer Leaf Springs