If Only Using One Set of Tire Chains on 4x4 Vehicle Which Axles Should Chains Go On

Question

Question:

Where should i put snow chains on a 01 chevy tracker 4x4 i cant seem to find it in manual and i only have one pair

asked by: Todd D

0

Expert Reply:

On 4 wheel drive vehicles you'd want to install the set of tire chains on the rear axle if you only have one set available.

expert reply by: Jameson C

0

Answer 1

Correct, you need the Konig Self-Tensioning Snow Tire Chains part #TH01594267 for a 2021 Jeep Grand Cherokee L with 265/50-20 tires and they must be installed on the rear tires only. These are the same chains referenced in the owner's…

view full answer...

Answer 2

When using a single set of tire chains on a vehicle that is 4 wheel drive or all wheel drive you want to install the chains on the primary drive axle. Typically this will be listed in the owner's manual. But for a 4WD drive vehicle the axle…

view full answer...

Answer 3

I am far from an expert on snowmobiles but one would have to think such a large truck with the correct tires and chains would be able to make it through up to 2' of snow assuming you have clearance on the vehicle. In regards to the type of tire…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…

view full answer...

Answer 6

The Dexter 10K electric brakes #23-439 (right side) and #23-438 (left side) will have to be manually adjusted using the adjustment wheel below the magnet. To adjust the brakes you will use a small screwdriver or similar tool to turn the adjustment…

view full answer...

Answer 7

I checked directly with BOLT for you, and they confirmed for me that your 2021 Chevy Silverado is absolutely compatible with their trailer hitch locks. Take a look at the accompanying photo, and if you have the same center cut key, the correct lock…

view full answer...

Answer 8

Yes, the Bolt Trailer Hitch Lock part #BL7023582 will work for you as it is a hitch lock designed for 2-1/2 inch hitches like what you have on your GMC 3500 truck. The usable portion of this lock is 3.55 inches. Check out the picture I attached for…

view full answer...

Answer 9

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 10

I spoke to my contact at Horizon Global. He said it is acceptable to mount the Bulldog Powered-Drive Kit #BD1824200100 to the slave jack itself. He also said that if you need to switch the motor wires to make it work correctly, that would be fine, as…

view full answer...

Answer 11

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 12

M12-1.5 and 1/2"-20 threads are not going to be interchangeable. The diameter of an M12 thread is only going to be 0.4724" while 1/2" threads are going to be 0.500" in diameter. We currently only have 1/2"-20 Lug Nuts…

view full answer...

If Only Using One Set of Tire Chains on 4x4 Vehicle Which Axles Should Chains Go On

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching