How to Determine the Correct Slipper Spring for 6,000 lb Axle
Question:
6 k dexter axles 15 inch tires and rims e rated tires rims 6 hole rims slipper springs need three for my 34 ft pj trailer car / equipment trailer 83 inches between fenders Thanks
asked by: Douglas S
Expert Reply:
The slipper spring we carry for 6,000 lb axles is the 5-Leaf Slipper Spring w/ Hook End # e67SR.
To figure out if this spring is going to work for you there is a measurement you will need to take. If you look at the accompanying diagram you can see that "C" is 27 inches. This is the length from the center of the eye to the end of the spring with the slipper; you can measure your current slipper spring to see if you have a similar measurement, keeping in mind that the current spring may have elongated or sagged so it may not be exactly 27 inches, but it should be close.
It is important to replace all your springs at the same time in order to keep the support of the trailer even throughout. It is also a good idea to use new bolts with a new spring as your older bolts are likely to have been subjected to wear; for replacement bolts you can use Spring-Eye Bolt with Locknut for Slipper Springs # 166079.
Products Referenced in This Question
Spring-Eye Bolt with Locknut for Slipper Springs - 3-1/2" Long
- Trailer Suspension Parts
- Suspension Bolts
- Camper
- Car Hauler
- Utility Trailer
- 9/16 Inch Diameter
- 3-1/2 Inch Long
- ABS Fasteners
more information >
Product Page this Question was Asked From
5-Leaf Slipper Spring w/ Hook End for 6,000-lb Trailer Axles - 27" Long
- Trailer Leaf Springs
- Slipper Springs
- Hook End
- 6000 lbs
- 2 Inch Wide
- 5 Leaf
- 27 Inch Long
- Painted
- etrailer
more information >
Continue Researching
- Shop: 4-Leaf Slipper Spring w/ Hook End for 5,000-lb Trailer Axles - 26-5/8" Long
- Shop: Dexter Single-Axle Trailer Hanger Kit for 2" Slipper Springs - 5" Front, 6-3/8" Rear
- Article: Slipper Spring Trailer Suspension System Review
- Q&A: Is There a Shorter Shackle Strap Kit That Can Be Used With Road Armor Equalizer Kit
- Shop: Grease Seal - Double Lip - ID 1.719" / OD 2.565" - for 3,500-lb Axles
- Shop: Replacement Trailer Hub Bearing - 1779
- Article: Trailer Wiring Diagrams
- Shop: Spring-Eye Bolt with Locknut for Slipper Springs - 3-1/2" Long
- Shop: Nylon Bushing - 9/16" Inner Diameter, 1.024" Outer Diameter - 1-3/4" Long
- Shop: Dexter Equalizer for 3" Wide Slipper Springs - 24-3/4" Long - 1-1/8" Center Hole
- Q&A: How to Determine Correct Slipper Spring Replacement for 1,500 lb Axle
- Video: Review of Stromberg Carlson RV and Camper Steps - Single Manual Step - SMFP-1100
- Video: Redline Trailer Suspension SP05-080 Review
- Search Results: shackle
- Search Results: leaf spring bushing
- Search Results: slipper leaf spring
- Video: TruRyde Trailer Suspension TRBU11568 Review
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Video: Cleaning and Replacing Hubs and Bearings
- Q&A: What Are the Torque Specs for Trailer Suspension Parts
- Q&A: Proper Torque Rating for Spindle Nut
- Search Results: karavan
- Q&A: Could Spring Eye-Bolt 166081 be Used with Leaf Spring SP-040275
- Q&A: Does Hitch Bolt 166097 Fit Slipper Spring part # e29SR
- Q&A: Replacement Electric Trailer Brakes for '66 Avion Trailer
- Search Results: 26 inch leaf spring
- Search Results: 4 way to 5 way adapter
- Search Results: bearing buddy
- Video: Brophy RV and Camper Steps NSAS Review