Troubleshooting Trailer Brake and Turn Signals Not Working
Question:
Hello, the right side turn signal and brake light stopped working. I thought it might be the bulb, so I switched the bulb from the left side, which was working fine. Now both sides have the same problem. I have running lights now only for both sides. Any ideas on whats going on? Thanks
asked by: Jeff H
Expert Reply:
There are a great number of potential issues that could be affecting your turn signal and brake light not working. The first thing to do is take a look at your owner's manual to locate where any trailer fuses or relays and ensure they are all there and in working order. If they are, in order to determine the specific problem you will need to use a circuit tester like the very handy Cordless Circuit Tester # PTW2979 to test the connector on your vehicle after disconnecting it from your trailer. Check the wiring going into your harness from your tail lights to see if those wires are carrying the correct signals, if not then the issue is with the vehicle wiring.
If the signals going to your harness are okay, you'll need to test the signals coming out of the harness, and if they are correct then your issue is likely going to be with the trailer side wiring. You will also want to check both your vehicle and trailer connectors for corrosion, which can be green or white in color. A build-up of corrosion can interfere with the signals getting through the connectors so if it is present you will need to either replace the plug or clean the corrosion.
An important issue you will want to take a look at are the ground connections, as they can be the cause of numerous lighting problems. You'll want to make sure your grounds are securely attached to bare metal surfaces free of any paint, dirt or corrosion of any kind. Also check your wiring thoroughly to ensure there are none that are crimped, broken or otherwise damaged.
I have added links to a pair of help articles on trailer wiring, including a troubleshooting guide which I highly recommend taking a look at.
Products Referenced in This Question
Product Page this Question was Asked From
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 0 - 5 Feet Long
- Plug and Lead
- 4 Flat
- Draw-Tite
more information >
Continue Researching
- Q&A: Does The Draw-Tite trailer Hitch Receiver Come With One Or Two Hitch Pin Holes
- Q&A: Replacement Hub and Drum Assemblies for AL/KO 8460 Hubs and Drums
- Q&A: Replacement Zerk Fitting Recommendation for Dexter EZ Lube Spindle
- Article: Trailer Wiring Diagrams
- Q&A: Can 12 Volt Accessory Circuit of Trailer Wiring Keep 10 Amp Breakaway Battery Topped Off
- Q&A: Recommended Roof Rack Crossbars for Lance Cab Over Camper With Factory Tracks
- Q&A: Can You Install a 5th Wheel Hitch On a 2021 GMC Sierra 2500
- Q&A: 4-Way Trailer Connector that has 5 Wires
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Tire Sizing
- Article: Brake Controller Installation: Starting from Scratch
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Troubleshooting 4 and 5-Way Wiring Installations