Will Winch Mount with Holes 2-3/4 inches Apart Fit Fulton XLT Winch
Question:
My trailer has threaded holes to mount the winch, which are 2-3/4inch apart center to center. Can you tell me the range from the single mounting hole to the front and the rear of the slotted mounting hole?
asked by: Andrew W
Expert Reply:
The distance between your winch mounting plate being 2-3/4 inches is compatible with the Fulton XLT Winch part # F142418 bolt pattern. This winch has the industry standard bolt pattern which is basically a triangle-shaped bolt pattern. The two bolts at the bottom are 2-1/4 inches apart on center. The top bolt is 4-1/2 inches from either bottom bolt on center. The slot length is 2-1/4 inches long.
Product Page this Question was Asked From
Fulton XLT 2-Speed Trailer Winch with Heavy Duty 20' Strap - Zinc - 2,600 lbs
- Trailer Winch
- Standard Hand Winch
- Boat Trailer Winch
- Utility Winch
- Heavy Duty
- Standard Hand Crank
- Two Speed Winch
- Polyester Strap
- Fulton
more information >
Continue Researching
- Q&A: Replacement for Knott 6S5810.001 AutoFlex 2500 lb 2-Speed Trailer Winch
- Q&A: Comparing Fulton F2 and XLT Winches
- Article: Trailer Wiring Diagrams
- Q&A: Recommended High-Speed Hand Winch for Light Loads
- Q&A: Depth of Hook Mechanism From End of BoatBuckle Boat Winch Strap
- Q&A: Can 5-Way with 6 Wires be Ran to 5-Way with 5 Wires
- Q&A: Mounting Hole Dimensions Of The Dutton-Lainson Hand Winch Part # DL15440
- Q&A: Boat Trailer Winch to Replace Old Shelby 5470A Winch
- Article: Hand Winches
- Article: How to Choose the Best Winch for You, your Boat, and your Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)