Troubleshooting Trailer Right Turn Light Always On
Question:
under hood fuse panel fuse number one power all times rt and stop truck lighting ok only trailer rt stop stays on all times
asked by: Mike O
Expert Reply:
It sounds like you have checked your fuses and they are good but the right turn signal on your trailer is still staying on at all times. If that is the case there is some troubleshooting you will need to do in order to determine the exact issue. You will need to use a circuit tester such as # PTW2979 to test the connector on your 2012 GMC Sierra after disconnecting it from your trailer. Check the wiring going into your harness from your tail lights to see if those wires are carrying the correct signals, if not then the issue is with the vehicle wiring.
If the signals going to your harness are okay, you'll need to test the signals coming out of the harness, and if they are correct then your issue is likely going to be with the trailer side wiring. You will also want to check both your vehicle and trailer connectors for corrosion, which can be green or white in color. A build-up of corrosion can interfere with the signals getting through the connectors so if it is present you will need to either replace the plug or clean the corrosion and be sure to use Dielectric Grease # LT37534 to help stop any future corrosion.
An important issue you will want to take a look at are the ground connections, as they can be the cause of numerous lighting problems. You'll want to make sure your grounds are securely attached to bare metal surfaces free of any paint, dirt or corrosion of any kind. Also check your wiring thoroughly to ensure there are none that are crimped, broken or otherwise damaged.
I have added links to a pair of help articles on trailer wiring, including a troubleshooting guide which I highly recommend taking a look at.
Products Referenced in This Question
Loctite Bulb, Lamp, and Electrical Connection Dielectric Grease - 0.33-Oz Tube
- Accessories and Parts
- Wiring
- Dielectric Grease
- Loctite
more information >
Product Page this Question was Asked From
Continue Researching
- Q&A: Testing for Proper Voltage on the Brake Output Circuit
- Article: Trailer Wiring Diagrams
- Q&A: How to Make an Adapter to Go from Semi Truck 7-Way Round to RV Style 7-Way Blade on Trailer
- Q&A: Can Electric Brake Controller Install and Function in Semi Truck with Air Brakes
- Q&A: Replacement Circuit Board For Dometic Atwood Water Heater With Circuit Board 91346
- Q&A: No Power to 12 Volt on 7-Way of 2020 Ram 3500
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: What is Most Common Leaf Spring Length for 3,500 lb Trailer Axle
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: How to Tell if 2019 Toyota Highlander Has Factory Tow Package
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Troubleshooting Brake Controller Installations
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)