Weight Distribution Shank Recommendation for Needing Hitch Drop of 10 inch
Question:
Im looking for a shank that will net a 10inch drop using the round bar e2 hitch. My receiver is 27inch high and I have a 2inch receiver. Do you have any suggestions for me? Thanks,
asked by: Scot A
0
Expert Reply:
The Curt shank part # C17124 can do up to a 9-1/2 inch drop when used with a round bar setup like your Fastway E2 round bar weight distributions system. The next largest drop we have would be the Curt shank part # C17125 which can do a drop of up to 16-1/4 inches which may be a bit too extreme.
expert reply by:
Jameson C
0
Products Referenced in This Question
Curt Weight Distribution Shank 13" Long - 9" or 10" Drop - 1,500 lbs TW
- Accessories and Parts
- Weight Distribution Hitch
- Shanks
- 1600 lbs TW
- 16000 lbs GTW
- Fits 2 Inch Hitch
- Round - 9 Inch Drop
- Trunnion - 7 Inch Drop
- CURT
more information >
Product Page this Question was Asked From
Curt Weight Distribution Shank - 12" Long - 15-3/4" or 16-1/4" Drop - 1,500 lbs TW
- Accessories and Parts
- Weight Distribution Hitch
- Shanks
- 1500 lbs TW
- 15000 lbs GTW
- Fits 2 Inch Hitch
- Round - 16 Inch Drop
- Trunnion - 15 Inch Drop
- CURT
more information >
Continue Researching
- Q&A: Replacement Jack Foot Pin for Easy Removal on Trails West Gooseneck Horse Trailer
- Q&A: Upgrade From 225/75R15 Load Range C Tire to Load Range D Tire on a Horse Trailer
- Q&A: Transmission Cooler and Temperature Gauge Recommendations for a 1996 Ford F-250, F-350
- Q&A: Can 2017 Ford F-150 with 2.7 Liter EcoBoost Engine Tow 8,100 lb Trailer
- Q&A: Parts Needed to Flat Tow a 2011 Ford Explorer Behind a Motor Home
- Q&A: Recommended Spare Tire Carrier For Class C Motorhome
- Q&A: Installing a 7-Way on 2017 Toyota Highlander
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Shop: Suspension Enhancement
- Shop: Brake Controller
- Shop: Fifth Wheel Hitch
- Shop: Gooseneck Hitch
- Shop: Towing Mirrors
Shaun S.
2/22/2020
Hi I recently purchased a 2015 tahoe that sits much higher than my 2013 highlander I traded in. It looks like I need about a 13 1/2” for my small single axle camper to sit level. I’ve got the curt trunnion style stabilizer bitch currently. Is this bar a good match ? Thanks in advance !