Does Adhesive of Rampage SuperBrite LED Tailgate Light Bar # RA960137 Hurt Clear Coat
Question:
Can this be applied directly to the bottom of the tailgate itself to provide better visibility and then removed sometime later without hurting the clear coat/paint?
asked by: Steven J
1
Helpful Expert Reply:
The 3M adhesive that the Rampage SuperBrite LED Tailgate Light Bar # RA960137 uses to secure to the rear of a vehicle is safe on clear coat. Removing it later would not cause any issues with the paint.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Rampage SuperBrite LED Tailgate Light Bar - Stop, Tail, Turn, Reverse - 4-Pole Flat - 49" Long
- Vehicle Lights
- Accent Light
- Tailgate Bar
- Single Light
- LED Light
- Light Assembly
- Strip
- Red/White
- Rampage
more information >
Continue Researching
- Article: Trailer Maintenance Schedule
- Article: How to Charge a Dump Trailer Battery
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: What Stops Porpoising on Tow Vehicle that is Using Weight Distribution with Trailer
- Q&A: Mobile Home Axle Conversion to Electric Trailer Brakes
- Q&A: Recommended Replacement Grease Seal for 2014 Shorelander Boat Trailer
- Q&A: Trailer Grease Seal to Replace 127194TB
- Q&A: Troubleshooting Trailer Tire Wear on the Outside Edge of the Tire
- Q&A: 205/75R14 Size Trailer Tire Needed with Load Range D and Speed Rating of at Least 81 mph
- Q&A: Recommended Lithium Battery Compatible Power Converter For Parallax 7355
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Hitch Receiver Sizes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams