How to Determine the Correct Replacement Hubs for a Trailer with a 3,500 Pound Axle
Question:
Hello, I am trying to figure out which hub kit I need for my Boat Trailer...it is a 3500LBS single straight axle. Old hubs were 5 studs with 4.5 spacing made by Dexter, with grease joint at end of hub. But Im not sure what type of spindle I have. What should I do?
asked by: Jack
Expert Reply:
There are a couple of things you can look at to determine the correct replacement hubs. The best way is to retrieve the inner and outer bearing numbers that are stamped into the bearings. I suspect that you will have the Trailer Hub Assembly, # 84545UC1-EZ, which uses L68149 Inner/L44649 Outer bearings and E-Z lube axles.
Or, for a hub and drum, # AKHD-545-35-EZ-K, which is the same but has the hub and drum for drum brakes. But, the best way to know is to check your bearing numbers.
The other thing you can do is measure the spindle. I have included a link to our spindle main page that shows the dimensions needed to identify the spindle. The measurements need to be as accurate as possible so I recommend using a set of dial calipers if you measure the spindle.
Products Referenced in This Question
Dexter Trailer Idler Hub Assembly for 3,500-lb Axles - 5 on 4-1/2 - Pre-Greased
- Trailer Hubs and Drums
- Hub
- EZ Lube
- Pre-Greased
- Standard
- L68149
- L44649
- For 3500 lbs Axles
- 5 on 4-1/2 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- Dexter
more information >
Easy Grease Trailer Hub and Drum Assembly for 3.5K Axles - 10" - 5 on 4-1/2 - Pre-Greased
- Trailer Hubs and Drums
- Hub with Integrated Drum
- Easy Grease
- EZ Lube
- Pre-Greased
- L68149
- L44649
- For 3500 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- etrailer
more information >
Product Page this Question was Asked From
Square #84 Spindle for 3,500-lb Trailer Axles - 1-1/2" Wide
- Trailer Spindles
- Standard Spindle
- 1-1/2 Inch Diameter
- Square
- For 3500 lb Axle
- TruRyde
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Trailer Grease Seal to Replace 127194TB
- Q&A: Recommended Replacement Grease Seal for 2014 Shorelander Boat Trailer
- Article: How to Charge a Dump Trailer Battery
- Q&A: Will the Correct Track Trailer Alignment and Lift Kit Prevent Nose High Towing
- Q&A: Does Correct Track Trailer Alignment Kit # RR23QX Come with Enough Brackets for Tandem Trailer
- Q&A: How Does the Correct Track Trailer Alignment and Lift Kit Really Work
- Q&A: Recommended Replacement For A WFCO WF-8750P Power Center
- Q&A: Is There Down Side to Progressive Dynamics 4000 Series 60 Amp Over 45 Amp
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Trailer Hitch Receiver Sizes
- Article: Trailer Maintenance Schedule
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Most Popular Wheel Bearings