Can Wire From Trailer Connector be Ran for Each Trailer Brake Axle
Question:
I am rewiring my utility trailer from a 6 plug to a 7 way RV slot....my question is...on the electric trailer brakes...can I run a blue wire down both sides of the trailer or do I have to run one and then cross over the axles like in your diagram?
asked by: Mark
0
Expert Reply:
You can run an individual wire for each brake axle on your trailer. You'd want to use 10 gauge wire like part # 10-1-1 (sold by the foot) and you'd be set.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Continue Researching
- Q&A: Parts Needed To Add Electric Drum Brakes To A Pontoon Trailer
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Tow Wiring for a 2023 Kia Telluride With LED Lights
- Q&A: Adding a Battery on an Enclosed Trailer to Power Interior Lights
- Q&A: What Gauge Wire Does The Curt USCAR Connector C56229 Use?
- Q&A: Can Electric Brakes be Used on a Boat Trailer
- Article: Brake Controller Installation for 2007 (New Body Style) - 2013 GMC Sierra and Chevy Silverado
- Q&A: How to Charge a Trailer Battery Through a 7-Way Connector
- Article: Testing Trailer Brake Magnets for Proper Function
- Q&A: What is the Proper Gauge Wire for Installation of a Brake Controller and Trailer Brakes