Will the Valterra # A01-2000VP Work if Inlet Locations are Swapped on OEM Hatch
Question:
My connections are opposite of this, meaning the city is on the left instead of the right.. will this still work?
asked by: Robert A
0
Expert Reply:
Since the gravity fill and city water inlets usually have a hose connected behind them you should be able to swap out your current hatch for the Valterra # A01-2000VP without a problem. I recommend taking your current hatch off to check that you have enough room for the hoses to reach (which you should).
expert reply by:
Jon G
0
Product Page this Question was Asked From
Valterra Lockable Dual RV Water Inlets - City Water and Gravity Fill - Brass Valve
- RV Water Inlets
- City Fill Inlet
- Gravity Fill Inlet
- Surface Mount
- 5-7/8 Inch Diameter Cutout
- 1/2 Inch Deep
- Plastic
- 7-5/8 Inch Diameter Flange
- Brass
- White
- Valterra
more information >
Continue Researching
- Q&A: How Much Work Is It To Swap Out A Dual Water Inlet With The Valterra lockable Dual Water Inlet
- Q&A: How to Determine if Buyers Products Hitch for Flatbed Trucks Will Fit a 1987 Chevy R30
- Q&A: Replacement A/C Roof Shroud for Duo-Therm 600315.321
- Q&A: Can you give me the dimensions of the Camco Cam Lock?
- Q&A: Brophy Aluminum Camper Scissor Bracket Width
- Q&A: Does Valterra City Water Inlet and Lockable Hatch Have A Check Valve
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: RV Propane 101: How Does My RV's Propane System Work?
- Q&A: Does JR Products RV City Water Inlet Replace B&B Inlet
- Article: Brake Controller Installation: Starting from Scratch
- Article: Converting Your RV Water Heater to Tankless
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Trailer Wiring Diagrams
- Article: The #1 RV Roof Maintenance Tip: Keep it Clean (Here's How)