Is There a Panel for Pollak Universal-Design Rocker Switch
Question:
Hi there, Do you sell a single switch panel that will fit this switch? I have to put a new panel in to support the switch, which Im using for two small heating pads for my water tank and line. Thanks
asked by: Josh H
Expert Reply:
Hi there!
The Pollak Universal-Design Rocker Switch # PK34310 does not have a specific panel available but I can tell you exactly what size the panel cutout needs to be for this to snap into place.
The switch will snap into a 0.830" wide x 1.450" tall cutout and will fit a panel that is 0.093", 0.125" or 0.187" thick.
I have added a link to a video review of this switch for you to check out as well.
Product Page this Question was Asked From
Universal-Design Rocker Switch - SPST - On-Off - 12 Volt - 20 Amp - 4-Blade - Red Pilot Light
- Accessories and Parts
- Wiring
- Switches
- Rocker Switches
- 20 Amp
- Pollak
more information >
Continue Researching
- Q&A: Can ThermaHeat RV Holding Tank Heater Run to Inverter Instead of Battery
- Q&A: Wiring Multiple Heater Pads to an On/Off Switch
- Q&A: Wiring Multiple Heating Pads to Switch Diagram
- Q&A: Can the ThermaHeat RV Holding Tank Heater Pads Drain a Trailer Battery
- Q&A: Gauge Wire Used on the 18-1/4" x 12" Holding Tank Heater Pad # 277-000164
- Q&A: How Long Can ThermaHeat RV Holding Tank Heater Pad 277-000164 Operate on RV Battery Power
- Q&A: How To Power The ThermaHeat RV Holding Tank Heater Pad With Thermostat - Item # 277-000164
- Article: Best Bike Racks for Electric Bikes
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Most Popular Wheel Bearings
- Article: How Much Trailer Can I Really Tow
- Article: Trailer Maintenance Schedule