Can Race Ramps Rally Ramps Be Trimmed At Wheel Stop for Low Car Compatibility?
Question:
Can you trim off a little of where the wheel stop is with out hurting the integrity of the ramp so it will fit under the rocker panel between the wheels of a low car
asked by: Chuck
Expert Reply:
I reached out to the manufacturer and the Race Ramps Rally Ramps - 30" Long - 5" Lift - Qty 2 # RR-30 cannot be modified. The outside coating really protects the integrity of the unit, so a modification could cause a significant difference in capacity. You would either want to use a jack to assist or want to use a different ramp like the Race Ramps Shop Ramps - Qty 2 # RR-SPR.
Products Referenced in This Question
Race Ramps Shop Ramps for Service and Load Assist - 4" Lift - 52" Long - Qty 2
- Car Ramps
- Loading Ramps
- Service Ramps
- Enclosed Trailer
- 14 Inch Wide
- 4 Inch Lift
- 52 Inch Long
- Car Hauler Ramps
- Lift Ramps
- Race Ramps
more information >
Product Page this Question was Asked From
Race Ramps Rally Ramps for Service and Display - 5" Lift - 30" Long - Qty 2
- Car Ramps
- Service Ramps
- 10 Inch Wide
- 5 Inch Lift
- 30 Inch Long
- Lift Ramps
- 3000 lbs
- Race Ramps
more information >
Continue Researching
- Q&A: Recommended 50 Amp to 30 Amp Adapter and Extension Cord Solution
- Article: Trailer Lighting Requirements
- Q&A: Will Race Ramps RR-56-2 Work with C7 Chevy Corvette Stingray
- Q&A: How to Determine Correct Wheel Stabilizers for Tandem Axle Trailer
- Q&A: Is the Ultra-Fab Chock and Lock Wheel Stabilizer Similar to a Wheel Chock
- Q&A: What is the Approach Angle for The Race Ramps Rally Ramps # RR-30 For Use On a 2019 Chevy Corvette?
- Q&A: Recommended Tire Clearance Between Tires on Dual Axle Trailer
- Q&A: Recommended Lightweight Ramp For Changing Oil in 2000 Chevy Sliverado
- Article: Rust Prevention