Recommended Tandem Axle Suspension Kit for Converting to Double Eye Leaf Springs
Question:
Hello, I’m changing my trailer from a tandem axle with slipper springs to a tandem axle with double eye springs. My questions are how do I figure out the appropriate vertical length of the equalizer? Should the mounting brackets for the equalizer and springs be the same length?. I’m going to be using two 2000lb axles. I have a total of 52” of length on aluminum Ibeam trailer to mount this setup. The tire size is 205/65-10
asked by: Jason
Expert Reply:
The appropriate vertical height of double-eye leaf spring equalizers and hangers mostly depends on the axle diameter. 2K axles typically have a diameter of 1-3/4-inches. If you were to use a tandem axle kit such as # APT5 which has hangers that are 3-3/4-inches tall and equalizers that match well you'll be all set.
It looks like you have just enough room to install this kit, as shown in the linked diagram. You will have about 5-inches of clearance between the trailer frame and the axle center which is plenty for proper functioning of the suspension. You can use 3-Leaf Double-Eye Springs # e84SR.
Products Referenced in This Question
Tandem-Axle Trailer Hanger Kit for Double Eye Springs - 3-1/4" Tall Front/Center/Rear
- Trailer Suspension Parts
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Tandem Axle
- etrailer
more information >
3-Leaf Double-Eye Spring for 2,000-lb Trailer Axles - 20-3/8" Long
- Trailer Leaf Springs
- Double Eye Springs
- 2000 lbs
- 1-3/4 Inch Wide
- 3 Leaf
- 20-3/8 Inch Long
- Painted
- etrailer
more information >
Product Page this Question was Asked From
Nylon Bushing - 9/16" Inner Diameter, 11/16" Outer Diameter - 1-3/4" Long
- Trailer Suspension Parts
- Bushings
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- 9/16 Inch ID x 11/16 Inch OD
- 1-3/4 Inch Long
- TruRyde
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Article: Double-Eye Trailer Suspension System Review
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Replacement Leaf Spring for 2021 Grand Design Imagine 3250BH
- Q&A: How Tight Should Shackle Straps and Bolts Be Tightened On Trailer
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Zerk Fitting For The UltraFab Weld-On Jumbo Steel Roller # UF48-979012
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Gooseneck Trailer Hitch for a 1996 Ford F-450
- Q&A: Replacement Leaf Spring for a Dexter 072-097-00
- Article: Trailer Tire Sizing
- Q&A: Comparing Bronze and Nylon Bushings for Trailer Suspension
- Q&A: Are Timken Trailer Bearings Made in USA
- Article: Trailer Maintenance Schedule