Does Replacement Remote to Air Lift WirelessONE Compressor Need to be Paired

Question:

Hello i bought a 2016 ford f250 diesel truck and it has the airlift airbags under it I bought a remote #72704 and I have no clue how to pair it. I found some,instructions on here but looks like it could be for a dully. The airbags are already hooked up how do I pair the remote I bought to make it work? Thanks so much

asked by: Harry O

Expert Reply:

The Replacement Remote for Air Lift WirelessONE Compressor System # AL72704 is a remote for the Air Lift WirelessONE Compressor System # AL25980 so this compressor system is what you will need in order to use the remote.

If you have this compressor system this is what you can do to sync the remote:

1. Turn ignition on.
2. Locate the sync wire in the wire harness.
• It will be the yellow wire that is looped with a yellow cap around it.
3. Remove the yellow wire from the cap leaving the cap attached to the harness.
4. Disconnect power to the receiver.
• Unplug the connector on the top.
5. Connect power to the receiver while grounding the sync input.
6. Listen for 3 clicks of the internal solenoid, then one click every second.
• This will indicate that you are now in the “sync mode”.
• Sync mode will last for 30 seconds total.
• Within the 30 seconds press any button on the transmitter to send a message to
the receiver.
• Once the receiver has received a message it will sync with that transmitter and stop
clicking the solenoid in 1 second intervals.
7. Reinsert the yellow wire terminal into the molded cap.