Tips for Seperating Connectors of Hopkins 7-Way Wiring Harness # HM43385
Question:
about to order part HM43385. ive played with existing wires, but cant get them to unhook. i have a history of breaking things i cant unhook. is there a trick, catch, etc? thanks
asked by: Brian W
Helpful Expert Reply:
The latches of the # HM43385 are reverse cam latches. Basically you will have to press down on the latch on the male side of the connector while pulling out at the same time. Sometimes connectors can be difficult to separate. I have found that if you press down on the release and then use a wide flat screwdriver between the two connectors to pry them apart that usually does the trick. A twisting motion with the screwdriver should do the trick.
Product Page this Question was Asked From
Hopkins Plug-In Simple Vehicle Wiring Harness for Factory Tow Package - 7-Way and 4-Flat Connectors
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 4 Flat
- 7 Round - Blade
- Hopkins
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacing Clamps on Extang Solid Fold Tonneau Cover
- Article: Trailer Wiring Diagrams
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Replacement 7-Way Trailer Connector for a 2004 Toyota Tundra with Factory Tow Package
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Replacement Hub and Drum and Hydraulic Brakes for a Cronkite Tandem Axle Trailer
- Q&A: Needing to Wire a 7-Way Connector to a 2004 Toyota Tundra
- Q&A: American Made Trailer Hitch Receiver for a 2000 Toyota Tundra
- Q&A: What is the Difference Between the Towable and Non-Towable Bumper on a 2002 Toyota Tundra
- Q&A: Trailer Wiring Recommendation for a 2011 Toyota Tacoma
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch