Dimensions of the Optronics Halogen Docking Light Kit
Question:
Do you have dimensions for the light? Can mount be attached to a vertical surface and still tilt light beam to be essentially horizontal? Or is a horizontal mounting surace required? Thanks
asked by: Robert L
Expert Reply:
I went out into our warehouse and pulled a Halogen Docking Light Kit # DL-16CC to measure and see if it could be mounted on a vertical surface and found that the dimensions are:
5-3/4 inches in width
2-7/8 inches in height
2 inches in depth
The mounting bracket of the lights pivots nearly 180 degrees and would allow you basically mount this on nearly any vertical or horizontal surfaces. Check out the video I put together for you that shows the measurements and the range of the pivoting mounting bracket.
Product Page this Question was Asked From
Halogen Docking Light Kit - 35 Watt - Lighted Switch and Safety-Fused Wiring - Black Housing
- Boat Lights
- Docking Lights
- Deck
- Black Housing
- Surface Mount
- Halogen Light
- White
- Optronics
more information >
Continue Researching
- Q&A: Replacement LED Flood Light for Load Lights on a Horse Trailer
- Q&A: Work Flood Light Fitment for 3-1/2" Wide x 2-1/4" High Spacing
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Check Valve Replacement for Lippert Hydraulic Slide Out
- Q&A: Interior and Exterior Horse Trailer Light Recommendations
- Q&A: LED Flood Light Recommendation for the Sides of a Horse Trailer
- Article: Trailer Wiring Diagrams
- Q&A: Dimensions of Lens for Optronics Halogen Utility Light
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommendations for Spare Wheel on 1965 Lil Loafer Trailer
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)