Recommended LED Light Load-Resistor for 2008 Ram LED Lights
Question:
I have a 2008 Dodge Ram and I put in led bulbs with a resister on both sides but the passenger side keeps blowing the resister to to the bulb
asked by: Gary R
0
Expert Reply:
Since it is just the passenger side load resistor blowing, I recommend using the LED Light Bulb Load-Resistor Kit # DI34ZRand installing in in a location where it will get more air movement so it can cool down. It is very likely that the load resister you have is overheating on that passenger side and using a resistor that has cooling fins and putting in near air movement will help.
expert reply by:
Jason S
0
Products Referenced in This Question
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Product Page this Question was Asked From
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Continue Researching
- Q&A: Solution for Rapid Signal Flashing on Utility Bed with LED Lights
- Q&A: LED Tail Lights Added to Flat Bed Truck Hyper Flash with Flashers/Turn Signals On
- Q&A: Are Load Resistors Required when Adding LED Lights to a Trailer
- Q&A: Are Load Resistors Needed for LED Backup and Brake/Tail Lights
- Q&A: What Is The Depth Of The Ventline Pinnacle Ductless RV Range Hood VE78SR
- Q&A: How Do I Install Load Resistors for the LED Lights on my 2007 Dodge 3500 Flatbed
- Q&A: Can You Back Up with a Curt Weight Distribution System Installed
- Article: Gooseneck to 5th Wheel Adapters
- Article: Top Weight Distribution Hitches for a Buttery Smooth Ride
- Article: Trailer Wiring Diagrams
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: Best Boat Accessories
- Article: Which Hitches are Made in the USA
- Article: Most Popular Wheel Bearings