How to Install Trailer Wiring on a 2004 Mitsubishi Endeavor Pulling a Boat Trailer with a 5-Way
Question:
I have a 2004 Mitsubishi Endeavor. My boat trailer has a 5 wire system. Can this wiring kit convert to the five wire plug? Trailer has a brake activation system.
asked by: Ken P
Expert Reply:
Yes, the fifth wire on your boat trailer is most likely a reverse lock-out solenoid for the surge brakes so that you can reverse your trailer without the brakes activating.
I would recommend you install this Curt T-Connector # C56039 on your 2004 Mitsubishi Endeavor (instructions attached) and then cut the 4-way off of the harness and then wire up a Hopkins Endurance 5-Way Flat Trailer Connector # HM47900 by function to the wires that are now exposed from the # C56039 to the # HM47900. And then with the fifth wire you will use a section of wire to run up and tap into the reverse light circuit of your vehicle and splice it in.
Now you will have a fully functional 5-way at the rear of your 2004 Mitsubishi Endeavor that will work on the 5-wire system of your boat trailer.
Products Referenced in This Question
Hopkins Endurance 5-Way Flat Trailer Connector - Vehicle End - Ergonomic Design
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- 0 - 5 Feet Long
- Plug and Lead
- 5 Flat
- Hopkins
more information >
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Trailer Wiring Harness for 2004 Mitsubishi Endeavor
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Bolts Provided with Hitch Will Not Fit in Nuts Welded Into Vehicle Frame
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Where is the Trailer Wiring Connection Point for a 2007 Mitsubishi Endeavor
- Q&A: Hitch and Wiring Install Instructions for a 2011 Mitsubishi Endeavor
- Q&A: Where Does the 4-Flat Connector from Wiring Harness # C56039 go on a 2010 Mitsubishi Endeavor
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Trailer Tires to Replace P165/80-13 and B78-13 Tires on a Boat Trailer