Distance Between the Mounting Holes of the Ram Scissor Stabilizer Jack # TJSC-24
Question:
My 4 existing self tapped holes in my travel trailer are oriented in a straight line along the frame. I would be using the 4, 5/8 inch by 3/8 inch mounting holes in the new jack to attach it with my existing self tapping screws. My existing holes for the 4 self tapping screws are approximately 1 inch , 4 inch and 1 inch apart respectively starting at 1 end and moving along the trailer frame. Will the TSJC-24 fit against those holes without additional drilling?
asked by: David V
Expert Reply:
I am attaching a photo of the mounting locations on the Ram Scissor Stabilizer Jack # TJSC-24 that I believe you were referencing. They are from the edges of the mounting holes but I believe your mounting hole locations would match up just fine. Let me know if you were talking about a different set and I can see what those are as well.
Attached is a review video for you to check out as well.
Product Page this Question was Asked From
Scissor Stabilizer Jack - 18-3/4" Travel - 2,500 lbs - Qty 1
- Camper Jacks
- Fifth Wheel Camper
- Pop Up Camper
- RV Motorhome
- Teardrop Camper
- Travel Trailer
- Stabilizer Jacks
- Steel
- 2001 - 3000 lbs
- Scissor Jack
- 18-3/4 Inch Lift
- Bolt-On
- 1 Jack
- etrailer
more information >
Continue Researching
- Q&A: Scissor Jack Options With A Low Retracted Height
- Q&A: Is New Mounting Hardware Needed For The etrailer Scissor Stabilizer Jack # TSJC-24
- Article: Trailer Wiring Diagrams
- Q&A: Trostel 324-216-8 Replacement Grease Seal
- Q&A: Replacement Stabilizer Jacks for 2020 Rpod 195
- Q&A: Can 3,500 lb Axle Trailer Leaf Spring 25-1/4 inch get Replaced with 5k Rated Spring
- Article: Trailer Tire Sizing
- Q&A: Recommended Weight Distribution System for 2009 Trailmanor 3124KB
- Q&A: Can I Upgrade My 3,500 lb Leaf Springs To 5,000 lb Springs If The Measurements Match?
- Article: Stability Control for Heavy Duty Vehicles
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Brake Controller Installation: Starting from Scratch
- Article: Most Popular Wheel Bearings
- Article: How to Choose the Right Trailer Hitch Class
Jerry S.
7/8/2020
I am replacing a bent jack on Casita travel trailer. The mounting bracket is welded to frame. I removed bent jack by removing the two bolts that connect jack to bracket. Can I remove the new jack from it’s bracket and replace the same way using the old brackets? Thanks.