Tow Bar Lighting Recommendation for 2008 Ford Edge
Question:
I NEED WIRING FROM 2011 TIFFIN ALLEGRO 44foot BUS TO 2008 FORD EDGE
asked by: BILLY B
0
Expert Reply:
For tow bar lighting for your 2008 Ford Edge you can use the diode kit, # RM-15267, and not have to worry about cutting into the taillight housing. This will splice into your taillight wiring to allow your tow vehicle to control the taillight assemblies of the towed vehicle. This comes with a round 6-way connector that you will install on the front of your towed vehicle and enough coiled wire to go from there to the RV.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit
- Tow Bar Wiring
- Splices into Vehicle Wiring
- Diode Kit
- Universal
- Tail Light Mount
- Roadmaster
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Must-Have Flat Towing Components
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Q&A: Choosing Between the Brake Buddy Select 3 and the Blue Ox Patriot Supplemental Braking System
- Q&A: All Parts Needed to Flat Tow 2014 Chevy Silverado 1500 Behind Motorhome
- Article: Flat Towing Package for 2018 Jeep Wrangler JL and JL Unlimited
- Article: Tow Bar Wiring: Which Wiring Kit is for You?
- Q&A: Is The Curt C96JR Tail Light Kit Compatible With A Brake Buddy Brake System?
- Q&A: What Is Needed To Safely Flat Tow A 2023 Chevy Silverado 1500
- Q&A: Rear Sway Bar and SumoSpring Kit for 2011 Itasca Cambria to Improve Handling
- Q&A: Does Blue Ox Base Plate Kit part # BLU85CR Have Safety Chain Connection Point
- Q&A: Parts Needed to Flat Tow 2024 Ram 1500 Behind Motorhome With Roadmaster Tow Bar