Does the Loose White Wire Need to be Connected on the Tekonsha Harness Part # 3031-P
Question:
3031 p plug in at controller side of Harness has a separate loose White ground wire Does this have to connected?
asked by: Mike
0
Expert Reply:
Yes, the loose white wire on the Tekonsha Custom Wiring Adapter for Trailer Brake Controllers part # 3031-P will need to be attached to a bare metal surface in order for a Tekonsha brake controller to function properly.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Tekonsha Custom Wiring Adapter for Trailer Brake Controllers - Dual Plug In
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Measure a Trailer Axle
- Article: Flat Towing Package for 2002-2004 Jeep Liberty
- Article: Adapters for Towing a 5th Wheel Trailer with a Gooseneck Hitch
- Q&A: Bearings For Older Trailer Hub 22834
- Article: Car Camping Checklist
- Q&A: Replacement For TDE-LP750 Trailer Actuator
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Options For Replacing A Tie Down Turbo Lube 48394 Clear Oil Bath Cap
- Q&A: Brake Controller Recommendation for 2017 Toyota Tacoma with Tow Package
- Q&A: Latch Repair Kit For Bulldog A256 2-5/16" Ball Latch Coupler
- Article: Flat Towing Package for 2005-2007 Jeep Liberty
- Q&A: Installation of Coupler Repair Kit # CP02-050
- Q&A: Installation Instructions for the Draw-Tite Hitch 75251 on a 2011 Dodge Dakota