Parts Needed to Install a Trailer Brake Controller on a 2002 GMC Safari
Question:
How to wire a brake controller in a 2002 GMC safari. I found the orange and blue wire but, where to go from here?
asked by: Carly
Expert Reply:
In order to install a trailer brake controller on a 2002 GMC Safari you will need to hardwire it to the vehicle. First, you will need a 4-Way trailer connector, # 18252 if you do not already have one. I have included a link to a video showing a typical installation.
With the 4-Way installed you will then need to install a 4 and 7 Way Installation Kit, # ETBC7. The 4-Way plugs into the back and all of the wiring and circuit breakers are included to install the brake controller. It will provide a 7-Way and 4-Way connector at the rear.
I have included links to an FAQ article and a video showing a typical installation of an ETBC7 for you to view.
If you need a brake controller, I recommend the Tekonsha P2, # 90885. It is one of our best sellers because it is easy to set up and easy to use. I have included a link to the installation details for you.
Products Referenced in This Question
4-Way Flat Trailer Connector w/ 72" Harness, Circuit Tester and Wire Taps
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- 6 Feet Long
- Universal Fit
- 4 Flat
- Tekonsha
more information >
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Product Page this Question was Asked From
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Ford, Lincoln, Mercury
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Recommended Replacement Brakes for a 2007 Pace Trailer w/ 15 Inch Rims
- Q&A: Parts Needed To Install a 7-Way and Trailer Brake Controller On a 1996 Ford F-350 With Factory 4-Way
- Q&A: Where is Brake Controller Install Port for 2018 Ford Explorer
- Article: Brake Controller Installation: Starting from Scratch
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: My Vehicle has a 4-Pin Trailer Plug, but Trailer has 7-Pin Trailer Plug
- Q&A: Best Brake Controller for a 2014 Fleetwood Bounder Motorhome
- Q&A: Location of Brake Controller Wiring Connector on 2014 Fleetwood Bounder on Ford F-53 Chassis
- Q&A: Brake Controller Recommendation for a 2021 Ford F-53 with Brake Controller Harness