Troubleshooting 3 Wire Strobe Light Function
Question:
Im replacing a standard three wire 4 inch light that is using only the white as ground and red for power. But when I installed the strobe and wired it the same the light will only come on when I unroll the electric tarp but when I go to close tarp it want light up.
asked by: John P
Helpful Expert Reply:
On the Custer 4-LED Strobe Light or Running Light - 3-Wire Pigtail - Red # STRL4R the black wire is the constant light power, the red wire is the strobe and the white wire is ground. It sounds like you either lose your ground or your constant power when your tarp is closed. I recommend using a circuit tester like # PTW2993 to test your wire functions in the closed position. It sounds like you are losing power and you will need to test that wire every few feet to determine where the short is if it isn't a ground issue.
Products Referenced in This Question
Product Page this Question was Asked From
Custer 4-LED Strobe Light or Running Light - 3-Wire Pigtail - Red
- Emergency Vehicle Lights
- Rectangle
- Surface Mount
- LED
- Wired
- 1 Flash Pattern
- Red
- Custer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How to Wire Custer 4-LED Strobe Light or Running Light STRL4A
- Q&A: How Do the Custer 3 Wire Strobe Lights Wire Up
- Article: Replacement Automotive Lighting
- Q&A: Can Custer Strobe Lights STRL4A be Powered By Running Light Circuit
- Article: Trailer Hitch Balls
- Q&A: Why Would Right Turn Signal Come on When Left Turn Signal is On for Trailer Wiring
- Q&A: How to Change Between Flash Modes on Custer Multi-Function LED Strobe Driver
- Q&A: Brackets and Grommets for Boat Trailer Lights