Air Lift 1000 Air Helper for Coil Springs Installation Hose on Top or Bottom?

Question

Question:

The instructions indicate to route the air house out the bottom of the spring but all the pictures and installation video show the air hose being routed out the top. The top seems like the preferred method to protect the air hose from damage. Please advise.

asked by: Brian

0

Expert Reply:

The Air Lift AirLift 1000 Air Helper Springs for Coil Springs - Rear # AL60732 can be installed for the air hose to be installed from the top or the bottom. The installation instructions give you the air hose routing from the bottom, but we have found the installation from the top to be easier in order to protect that air line. Their installation video of this product also uses the installation where the hose comes from the top.

expert reply by: Jason S

0

click to enlarge

Answer 1

I spoke with my contact at Curt regarding the Curt Class III Ball Mount with 2 Inch Ball #C45056 referenced in your question. He did state that the ball mount can be used in the rise position, which will indeed provide a 2 inch rise. The issue with…

view full answer...

Answer 2

Using a suspension enhancement system like the AirLift 1000 Air Helper Springs, part #AL60732 will not increase the load-carrying or tongue weight capacity of your 2015 Sienna. These are designed to help cushion heavy loads and help keep the…

view full answer...

Answer 3

Ideally a hitched trailer will be level to the ground. We often recommend starting off with the hitch ball being a bit higher - an inch or so - than the top of the coupler on the level trailer since once hitched there will be a degree of squat in the…

view full answer...

Answer 4

Thank you for your recent purchase including an extra-long Curt 2-inch ball mount #D-26. This particular ball mount offers a choice of 3/4-inches of rise or 2-inches of drop relative to the hitch receiver opening. If you need an extra-long ball mount…

view full answer...

Answer 5

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 6

We do have some suspension enhancement systems (SES) that will help to stabilize and level your van when carrying heavy loads. They are designed to assist suspension that is in good working condition, but do not increase your towing capacity. I…

view full answer...

Answer 7

Based on my research it looks like the factory towing package for the 2018 Toyota Sienna consists of an engine oil cooler along with a heavy-duty radiator and fan. The factory towing package is standard for the XLE model like what you have. With the…

view full answer...

Answer 8

To install the AirLift 1000 Rear Helper Springs, part #AL60732, in your 2004 Toyota Sienna you will need to either jack up the rear of the vehicle or raise it on a hoist and support the vehicle frame with safety stands. This is necessary to allow the…

view full answer...

Answer 9

I have a solution for you. As far as the load rating of the single Stallion Loading Ramp - Steel - 48" Long x 11" Wide #288-07474, it has a weight capacity of 800 pounds. However, when you use the ramp as a pair like the 2 that come with…

view full answer...

Answer 10

In regards to loading ramps like the Loading Ramp part #288-07474, the length includes the lip/tabs on the top or bottom.

view full answer...

Answer 11

I would recommend using the Brake Controller 7 and 4 Way Installation Kit, item #ETBC7, along with the Tow Ready Harness, #118449, that you have installed on your vehicle. This kit has all of the wiring, circuit breakers and connectors that are…

view full answer...

Answer 12

It cannot; the brake control wiring is underneath the dash, which is why the Echo Under-Dash (and all in-cab brake controllers) have to be mounted near that wiring in the front of the vehicle, underneath the dash. If you're okay with that, for…

view full answer...

Air Lift 1000 Air Helper for Coil Springs Installation Hose on Top or Bottom?

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching