Fuse Locations for Trailer Running Lights on 2011 Ram 2500
Question:
2011 ram 2500 running trailer lights I just read the response to a previous question on this thread and Im hoping you might be able to tell me where I would find the relay for the running lights?
asked by: AJ
Expert Reply:
I took a look at the online version of the owner's manual for your 2011 Ram 2500 and found a couple of fuses you will want to check inside the power module located in the engine compartment. There should be a 40 amp green fuse located in the J01 position and a 20 amp blue fuse in the J14 position. Both of these fuses are related to trailer lights so you will want to check to make sure they are present and in good condition.
If the fuses are good and you are having issues with the trailer running lights, please let me know and we can continue to troubleshoot other possible causes.
Keith
3/1/2024
This information was 100% spot on to solve my issue of not getting 12v at the 7 pin connector on my 2012 Ram 2500. The 40a fuse at J1 was blown due to the body shop f***ing up my trailer wiring harness when they replaced the driver's side bed side. Thanks!!!
Rob C.
7/16/2020
Chris R. Thank you so very much! I also have a 2011 Ram 2500. I rented a U-Haul trailer tonight and once it got dark noticed that the running lights were not working. I found your message as well as the burned-out 20 amp J14 fuse within a few minutes. I swapped out a 20 amp fuse from a circuit that I wouldn’t need tonight and I’m on my way again. Thanks again – you’re a lifesaver!
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: RV Roof Membrane
- Search Results: lc142178
- Shop: Trailer Hub and Drum Assembly - 7,000-lb Axles - 12" Diameter - 8 on 6-1/2 - Pre-Greased
- Shop: Replacement Lead Leg for Venture 5th Wheel RV Landing Gear
- Shop: Landing Gear Set - 36-1/2" Lift - 8,000 lbs
- Shop: Replacement Follow Leg for Keystone Montana 5th Wheel Landing Gear
- Shop: Landing Gear Set w/ Handle - 36-1/2" Lift - 8,000 lbs
- Shop: Replacement Gearbox for etrailer and Ram 5th Wheel Landing Gear
- Shop: Gooseneck Hitch
- Shop: Nerf Bars - Running Boards
- Q&A: Troubleshooting 2011 Dodge Ram No Running Lights on Trailer, Brakes and Turn Signals OK
- Shop: Suspension Enhancement
- Shop: Bulldog Gooseneck Coupler - Adjustable - Round - 2-5/16" Ball - 20,000 lbs
- Video: Buyers Products Water Cooler Mount Review and Installation
- Shop: Trailer Wiring
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Q&A: Locations of 12V Power and Trailer Lighting Fuses in 2012 Dodge Ram
- Q&A: No Trailer Running Lights Troubleshooting on a 2012 Dodge Ram 3500
- Q&A: Troubleshooting Lack of 12V Power at 7-Way Trailer Connector on 2019 Ford F-150
- Q&A: Trailer Fenders for 33 Inch BFGoodrich Mud Tires
- Q&A: Trailer Lights Left Side Turn Signal and Brake Lights Not Working
- Search Results: pollak 11 932
- Shop: Camper Tie-Downs
- Video: Best 2014 Audi Q7 Trailer Wiring Options
- Shop: Trailer Hitch
- Search Results: tekonsha 119147
- Search Results: hopkins 7 way
- Search Results: 7 way connector
- Search Results: 119190
Juan
4/14/2024
I try but no power to the hitch plug , I found out there is 3 fuse dead The turn signals lights work and the brake lights work but no power for running lights