Distance from Center of Each Pin Hole to Weld on Shank for B&W Tow and Stow Ball Mount # BWTS10049B

Question:

Good day! What is the distance from the center of each receiver pin hole to the backside of the pin block or where the weld starts? The receiver on my Jeep is set in a little ways. Thanks guys and gals!

asked by: Matt

Expert Reply:

For the B&W Tow and Stow ball mount # BWTS10049B the distance from the weld to the center of the closest pin hole is approximately 2-3/4 inches. To center of the furthest pin hole it is approximately 3-7/8 inches. The measurements are approximate because the weld from one of these ball mounts to the next isn't exactly the same. I have linked a video review of this ball mount for you.

expert reply by: Michael H