Depth of the Namsco Wheel Cover Part # NA7160B0
Question:
I have hubs that stick out a bit on my 1997 4Star Horse trailer. How deep are these covers? Thanks.
asked by: Cézanne
0
Expert Reply:
I went out to our warehouse and measured the Namsco Wheel Covers part # NA7160B0 for you. The distance from the center circle to the outer edge of the cap not including the metal tabs is 3". The covers are designed to fit a 16" diameter wheel. I have attached a photo to assist.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Namsco Wheel Covers - 16", 8-Lug Wheels - 8 HH - Front/Rear
- Wheel Covers Hubcaps
- Wheel Covers
- Front and Rear Wheels
- 8 Hand Holes
- 8 Lugs
- 16 Inch Wheels
- Stainless Steel
- Namsco
more information >
Continue Researching
- Q&A: Will The Namsco Wheel Covers Fit A Chevy Workhorse With 16" Wheels
- Q&A: Wheel Cover Recommendation for a 2013 Ford E-350 Single Rear Wheel
- Q&A: Replacement Lug Nut Covers For 22.5 Alcoa Wheels
- Q&A: Recommended Exterior Light For An Enclosed Trailer That Runs Off Of 110V
- Q&A: Replacement Shroud for Coleman 7330-713 RV Rooftop Air Conditioner
- Q&A: Recommended Polish for Aluminum Trailer Exterior Walls
- Q&A: Can a 2017 Chevy Colorado 4WD be Flat Towed & Parts Needed
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them
- Article: The Basics: Firestone Air-Spring Kits
- Article: Best Air Bag Suspension (2023)
- Article: Frequently Asked Questions About Transmission Coolers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)