Wiring Harness to Install Hopkins Impulse Brake Controller in a 2018 Toyota 4Runner w/Tow Package

Question:

I have a 2018 Toyota 4Runner and an Hopkins Impulse Break Controller, I just need to know what parts I can use to connect these two things together? It has the two package just need to add the break controller.

asked by: Christy

Expert Reply:

I did some checking and the 2018 Toyota 4Runner uses the same brake controller wiring harness as the previous 2 model years. That means you can use # HM47815 with your Impulse brake controller.

But, I actually recommend a different approach because the factory ground on the Toyota tow packages where a brake controller plugs in has proven to be insufficient for many brake controllers. I propose using harness # 3041-P which has a separate ground wire to combat that issue. You would have to cut off the connector on the brake controller leaving just the wires and cut off the end of the 3041-P harness that does not plug into the truck. Then it is just a matter of hardwiring the 2 together color for color.

expert reply by: Michael H

Joseph P.

9/5/2020

I have a 2018 Chevy Colorado LT I'm wondering what parts I need to install my trlr brake system?

Jon G.

9/7/2020

There should be a bundle of wires under your driver's side dash that you'll hardwire a brake controller, like the Prodigy P3 # 90195, to. If you don't have a factory trailer connector at the back then you'll also need the wiring kit # HM11141144.