How Does the Stromberg-Carlson Electric Jack Wire for Installation
Question:
I suppose the electric tongue jack S/C Jet 3500 is connected to the + side of the battery. Correct?
asked by: Ray S
0
Expert Reply:
Typically these powered jacks would get their power from a trailer mounted battery that is maintained via the 7-Way on the truck. The truck would keep the battery topped off when towing down the road and the jack would pull the amperage it needs from the trailer battery.
So yes, you would attach this Electric A-Frame Tongue Jack # JET-3555 to the positive side of the battery for installation.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Stromberg Carlson Electric Trailer Jack - Drop Leg - A-Frame - 24" Lift - 3,500 lbs - White
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 24 Inch Lift
- Bolt-On
- Weld-On
- 1 Jack
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Best Solution For Gaining Tail Gate Clearance On A-Frame Trailer Tongue Jack
- Q&A: Can Generator Be Ran While Installed on MORryde RV Generator Slide Out Tray
- Q&A: Fuse Location for 12-Volt Accessory Feed to 7-Way Trailer Connector on 2005 Chevy Silverado
- Q&A: Recommended Weight Distribution System To Tow An ATC Game Changer 2513 Travel Trailer
- Q&A: Using Trailer Jacks To Transport A Yakups Kayak Carrier
- Article: Trailer Wiring Diagrams
- Q&A: Best Weight Distribution System for Towing a 28 ATC Aluminum Trailer with a 2017 Ford F-350
- Q&A: Is MaxxAir MaxxFan Mini Roof Vent w/ 12V Fan Switch Circuit Board Accessible
- Article: Best Camper Jacks
- Article: What is an RV-Approved Bike Rack? (And Do You REALLY Need One?)
- Article: How to Carry Bikes While Towing a Travel Trailer
- Article: Trailer Jacks
- Article: Performance Chips and Modules
- Article: How to Raise Your Travel Trailer Height