Is Drilling Required to Install a Trailer Hitch on a 2017 Jeep Renegade Latitude
Question:
i have a leased vehicle so cant make any new holes. Will this fit into existing frame without any drilling or enlarging of holes? It wasnt clear from feedback if that might be needed. I have a 2017 jeep renegade latitude
asked by: Terry
0
Expert Reply:
Products Referenced in This Question
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 525 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 675 lbs TW
- 4500 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: What is Max Safe Tire Temperature
- Q&A: What Size Battery Is Needed for the Lippert 6-Point Ground Control
- Q&A: Could GO Power Solar Panel kit part # 34273836 Mount to Pin Box and Use SAE Port
- Q&A: Bolts and Bracket for the Tie Down Caliper to Kodiak Caliper
- Q&A: Recommended Replacement Hub Assemblies for a Trailex Trailer with a 8 inch Wheel with 4 Bolts
- Q&A: Size of Hole Saw to Use to Install the Recessed Trailer D-Ring Tie Down RR5K
- Q&A: Can I Charge My Trailer Battery Using 7-Way Trailer Connector on Truck
- Article: How to Choose the Right Trailer Hitch Class
- Article: My Trailer Hitch Doesn't Fit
- Article: Most Popular Wheel Bearings
- Article: Trailer Tire Sizing
- Article: Performance Chips and Modules
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: How Long Can You Boondock in an RV?