Replacement Front Roller Bolt, Hex Nut and Lock Washer for Titan Model 10 Brake Actuator
Question:
Thanks for answer!! Was pressed for time so I ordered them assuming I could find the nuts. I was also curious if you could tell me the nut required for the T0829400? Thanks again!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
asked by: Alan
Helpful Expert Reply:
The Replacement Front Roller Bolt for Titan Model 10 Brake Actuator # T0828800 takes the Hex Nut for Titan Model 10 Brake Actuator - 1/2"-13NC # T0798500. To go with the bolt and nut you can also use the Replacement Lock Washer for Titan Model 10 Brake Actuator - 1/2" # T0793700.
Each of these parts are available through us; you can simply scroll down a bit and click on the "Add to Cart" button for each product and you'd be all set.
Products Referenced in This Question
Replacement Lock Washer for Dexter Model 10 Brake Actuator - 1/2"
- Accessories and Parts
- Brake Actuator
- Disc Brakes
- Hydraulic Drum Brakes
- Hardware
- Washers
- Dexter
more information >
Replacement Hex Nut for Dexter Model 10 Brake Actuator - 1/2"-13NC
- Accessories and Parts
- Brake Actuator
- Disc Brakes
- Hydraulic Drum Brakes
- Hardware
- Nuts
- Dexter
more information >
Replacement Rear Roller Bolt for Dexter Model 20 Brake Actuator
- Accessories and Parts
- Brake Actuator
- Disc Brakes
- Hydraulic Drum Brakes
- Hardware
- Rollers
- Bolts
- Dexter
more information >
Product Page this Question was Asked From
Replacement Front Roller Bolt for Dexter Model 10 Brake Actuator
- Accessories and Parts
- Brake Actuator
- Disc Brakes
- Hydraulic Drum Brakes
- Rollers
- Bolts
- Dexter
more information >
Continue Researching
- Q&A: Replacement Inner Slide Assembly for a Dico Model 10 Actuator
- Q&A: Where Do the Rubber Bearings Go On the Titan/Dico Model 10 Surge Brake Actuator
- Q&A: Advice on Replacing Old Surge Brake Coupler with Non Surge Straight Box Coupler Shaft
- Q&A: Are Kodiak Hydraulic Brake Line Kits Compatible With Titan/Dexter Model 10 Surge Brake Actuators?
- Q&A: Replacement Axle for AL-KO T35 3,500 Pound Axle with 85 Inch Hub Length
- Q&A: Recommended Replacement Inner Slide For Titan 10 Actuator
- Q&A: Are There Instructions To Replace the Breakaway Lever On a Titan Model 6 Actuator
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: How to Measure for Trailer Hitch Drop
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: How to Bleed Your Trailer Surge Brakes
Alan
6/2/2018
Thanks for answer!! Was pressed for time so I ordered them assuming I could find the nuts. I was also curious if you could tell me the nut required for the T0829400? Thanks again!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!