Will CURT 20x60 Folding Cargo Carrier Clear the Rear Bumper of a 2003 Honda Pilot
Question:
I installed the 18131 folding carrier on a 2003 Honda Pilot. When installed in the closer position to the vehicle, the basket hits the bumper before it can be locked into place. It falls just barely short of being able to place the pin in. Did I install it incorrectly or is there an adjustment that can be made? Or does the basket have to be moved to the rear position to fold up. Thanks
asked by: Alan S
Expert Reply:
On the 20x60 Folding Cargo Carrier, # C18151, the distance from the center of the hitch pin hole to the nearest part of the carrier when it is folded measures 6 inches. This is with the basket part in the near or far position. It is possible that by moving the basket to the far position it could clear the bumper and allow you to fold it up but the only way to tell is to make the adjustment and see.
On a 2003 Honda Pilot we installed a trailer hitch on, the distance to clear the rear bumper was 5-1/2 inches. If you cannot get the carrier to fold, I recommend a new carrier, # 6502, that is 7-1/2 inches from the center of the hitch pin hole when folded up. I have included a link to the installation details and a video review.
Products Referenced in This Question
20x48 Reese Cargo Carrier for 2" Hitches - Steel - Folding - 500 lbs
- Hitch Cargo Carrier
- Flat Carrier
- Folding Carrier
- 20 Inch Wide
- Heavy Duty
- Fits 2 Inch Hitch
- 48 Inch Long
- Class III
- Class IV
- Steel
- Reese
more information >
Product Page this Question was Asked From
20x59 Curt Cargo Carrier for 2" Hitches - Steel - Folding - 500 lbs
- Hitch Cargo Carrier
- Flat Carrier
- Folding Carrier
- 20 Inch Wide
- Heavy Duty
- Fits 2 Inch Hitch
- 60 Inch Long
- Class III
- Class IV
- Steel
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Rooftop Cargo Carriers
- Article: How to Choose the Right Trailer Hitch Class
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Comparing Curt and Reese Hitch Mounted Cargo Carriers
- Article: Cargo Tie-Down Methods
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Is Modification Required To Install The Curt C26VV On The 2024 Toyota Grand Highlander?
- Q&A: 2024 Lexus ES 350 Trunk Mount Bike Rack Recommendation
- Q&A: Does Xtreme Off-Road Trailer Jack Come With Bearings Installed
- Q&A: Recommended Hitch Mounted Cargo Carrier For Toyota Tacoma
- Q&A: Does the Heat Shield Have to Be Removed to Install the Curt C23HR on a 2021 Hyundai Sonata?
- Article: Trailer Hitch Receiver Sizes
- Article: Rust Prevention
- Article: Hitch Mounted Cargo Carrier Information