Mounting Bolt Pattern for the Hook and Keeper for Enclosed Trailer Door PLR9-SS
Question:
I currently have a broken OEM plastic door latch that I want to replace. It is the most common 6 Inch plastic T entry door holder, which you can get at Walmart or Camping World. It is like the RV Designer E235. I would rather get a metal one that wont break. However, I do not want to drill more holes in my RV. Will this product use the same holes as the old, generic, plastic T entry door holder?
asked by: B K
Expert Reply:
You'll have to measure to be sure as the mounting holes of the Hook and Keeper for Enclosed Trailer Door # PLR9-SS that you referenced are 2-5/16" (horizontal) x 1" (vertical) - center to center.
Product Page this Question was Asked From
T-Style Hook and Keeper Door Holder for Trailer Rear or Side Door - 4" Hook - Stainless Steel
- Trailer Door Holders
- Hook and Keeper
- T-Style Hook
- 4 Inch Hook
- 2-5/16 x 1 Inch Hole Spacing
- Stainless Steel
- Polar Hardware
more information >
Continue Researching
- Q&A: What is the Wizard Button for on the Progressive Dynamics RV Power Control Center
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: How To Install Steps on a 2016 Coachmen Leprechaun 317SA
- Article: Stability Control for Heavy Duty Vehicles
- Q&A: Can The T-Style Hook and Keeper Door Holder # 37210525 Be Mounted Horizontally?
- Article: What To Look For When Buying Ratchet Straps
- Q&A: What is Included with Lippert Kwikee 38 Series Electric Step # LC3723383
- Q&A: What is the Difference Between Load Range C and Load Range D Tires
- Q&A: How to Measure Width and Bolt Pattern on a Trailer Wheel
- Q&A: Wiring Diagrams for Installing Bright Way Trailer Breakaway ICU Kit # BW94FR
- Article: Big Truck Big RV
- Article: Best Camper Jacks
- Article: Performance Chips and Modules