Lift Kit Compatibility with 2016 Winnebago WD170S Trailer
Question:
I have a 2016 Winnebago Winnie Model # 170S. I would like to raise the height of the trailer a few inches as this model year is pretty low to the ground and the back end often drags pulling into gas stations etc. Could you tell me which product part # you recommend? Thank you.
asked by: Bill F
Expert Reply:
Your 2016 Winnebago Winnie WD170S has a Lippert torsion axle. If your mounting holes on your axle are 8 inch on center holes, then the Torflex Lift Kit - Single Axle - 2-5/8" Lift # K71-707-01 will work for your trailer. Lippert doesn't have the top mounted torsion axles that these are not compatible with, but they are also not compatible with 3 inch profile brackets.
Product Page this Question was Asked From
Torflex Lift Kit - Single Axle - 2-5/8" Lift
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Single Axle
- Dexter
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Seal With Dimensions to Replace 171255UC
- Q&A: How to Measure Hub Face of Mobile Home Hub and Drum
- Article: Trailer Tester Battery Replacement for Part Number 8010
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Parts Needed to Install Brake Controller on 2012 Chrysler Town and Country
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: 2022 Toyota Highlander Wiring for a 7-Way Blade Connector
- Q&A: Troubleshooting Brake Override and Stop/Start Malfunction On 2022 Toyota Highlander Redarc Tow Pro
- Q&A: Replacement for Demco Master Cylinder 05680-C for Drum Brakes
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: How to Choose the Right Trailer Hitch Class
- Article: How Long Can You Boondock in an RV?
- Q&A: Damaged Caused to Travel Trailer Brake Drums and Bearings by High Temperatures