How to Install the Hopkins Agility # HM47295 on a 2011 Chevrolet Silverado
Question:
Install brake control part number 47294 on a 2011 Chevy Silverado 1500 need to know how
asked by: KEITH A
Helpful Expert Reply:
Your 2011 Chevrolet Silverado should already have a 7-Way installed. If it doesn't then you need to locate the 7-pole connector located behind the bumper and install the Pollak Twist-in 7-Way Connector # PK11916.
After this you need to move to the cab of your Silverado to install the Hopkins Agility # HM47295. Under your drivers side dash there is a bundle of wires tied together with white tape to the left of the brake pedal. Carefully cut the white tape and connect the following wires from your Silverado to the following wires on the Agility:
Red - Black
Dark Blue - Blue
Light Blue or Orange - Red
White - White
Next you need to move to under the hood and connect the ring terminals for the 12V power and brake controller output pins for your 7-Way if those are not already connected. There also may be some fuses that need to be installed.
All of this is covered in the attached installation article. I have also linked a video of the Tekonsha Prodigy P3 # 90195 being installed on a 2011 Silverado that you can reference.
Products Referenced in This Question
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Twist-in, 7-Pole, RV-Style Trailer Connector for Chevy and GMC Vehicles - Vehicle End
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 7 Round - Blade
- Pollak
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: No Power On Blue Wire to Trailer Brakes from Brake Controller
- Q&A: Troubleshooting Hopkins Trailer Brake Controller That Does Not Show Connection to Vehicle