6-Way Round to 4-Way Adapter

Question

Question:

I need an adapter that has on one end a female small round six pole to a flat 4 with 3 male poles and 1 female pole.

asked by: Jamey M

0

Expert Reply:

Sounds like you are looking for an adapter like the part # A10-6034VP. This has a 4-way on one end like you mentioned and then has a 6-way socket on the other.

I attached a review video for this adapter for you to check out as well.

expert reply by: Jameson C

0

Answer 1

When wiring the Roadmaster Battery Charge Line Kit #RM-156-25 to the Blue Ox 7-Wire to 6-Wire, Coiled Electrical Cord #BX88206 the red wire coming from the battery will go to the 7 Way port in the 1 o'clock position when looking at the back…

view full answer...

Answer 2

We do not currently a Blue Ox wiring kit compatible with a 2011 Jeep Wrangler but we do carry the Hopkins Custom Tail Light Wiring Kit for Towed Vehicles #HM56200 which will plug into your Jeep's tail lights for an easy peasy installation.

view full answer...

Answer 3

The easiest way to connect your towed vehicle to the 7-Way on your RV will be to use a cord like the Blue Ox 7-Wire to 6-Wire Coiled Electrical Cord #BX88206. This will allow you to quickly connect your tow vehicle to your RV by using the included…

view full answer...

Answer 4

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 6

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 7

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 8

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 9

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 10

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 11

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 12

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

6-Way Round to 4-Way Adapter

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching