Will a 2-1/2 Inch to 2 Inch Trailer Hitch Receiver Reducer Sleeve Fit a 2005 Ford F-350 Super Duty
Question:
Will this fit my 2005 f 350 super duty? Will the pin hole line up? How long is this part? I see 2-1/2 inches and also 5 and 1/2 inches in the descriptions. thanks.
asked by: Bob
0
Expert Reply:
The overall length of the Curt Reducer Sleeve, # 58102, is 5-1/2 inches. The distance from the back to the center of the hitch pin hole is 2-1/2 inches.
It is designed for factory installed and aftermarket trailer hitches with a 2-1/2 inch receiver. If your 2005 Ford F-350 has a 2-1/2 inch receiver then this sleeve should fit. I recommend taking some measurements of your hitch and comparing them to those on the product page to determine fit.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Curt Hitch Receiver Reducer Sleeve - 2-1/2" to 2"
- Hitch Adapters
- Hitch Reducer
- Bike Racks
- Cargo Carriers
- Hitch Mounted Accessories
- No Extension
- Fits 2-1/2 Inch Hitch
- 2-1/2 Inch to 2 Inch
- CURT
more information >
Continue Researching
- Article: How to Measure for Trailer Hitch Drop
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: 2023 Best Gifts for Haulers & Towers
- Q&A: Will The Curt Base Plate # C36JR Fit a 2020 Ford Expedition And Blue Ox Tow Bars?
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Q&A: Can a Furrion Replacement Glass Top be Used on Magic Chef MCFR21TTB RV Stove
- Article: Trailer Hitch Receiver Sizes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommended Replacement Drop Leg for a Bulldog Tongue Jack
- Article: Trailer Wiring Diagrams
- Q&A: Does this Front Mount Hitch Fit a 2024 Ram 2500 w/ a Diesel Engine?
- Q&A: Replacement Stereo Upgrade Recommendation for Drive EEDV06 in RV
- Q&A: Replacement Wheel Stud for Lippert 3,500 lb Axle
- Q&A: Replacement Bearings and Seals Based On Printed Number On Face Of Bearing