Installation of Waste Master Sewer Hose System on a Tiffin Motorhome

Question:

I am considering replacing my bayonet fitting on my Tiffin MH with the Wastemaster system. Since my black water ABS fitting takes a 90 degree turn and then exits the bottom of the motorhome I will only have a 1 1/4 “ glue surface to glue the camlock fitting to the my existing sewer connection. Will that make the joint sufficiently strong enough handle the Wastemaster sewer hose when in use. Also, what is the length of the fitting.

asked by: Duane T

Expert Reply:

There isn't a minimum amount of space listed as being required between the Waste Master female end and the pipe on the RV. That 1-1/4 inches you have will be sufficient for Waste Master system # LC359724. The overall length of the female fitting is approximately 4-3/8 inches.

The proper glue to use will be an ABS solvent, # A05-0303. Apply it to both the female part of the Waste Master and the RV pipe. Push on the female end and rotate 90 degrees and hold it there for at least 30 seconds. It takes about 15 minutes or so to dry.

expert reply by: Michael H