Is Fascia Trimming Required to Install Draw-Tite Class I Receiver on 2010 Toyota Matrix S
Question:
Will the 24812 hitch fit a Matrix S w/o any cutting of the plastic? Thanx
asked by: Stan S
0
Expert Reply:
According to my contacts at Draw-Tite, no fascia trimming or other modification is necessary for installing the Class I Receiver, part # 24812 on your 2010 Matrix S. On the XR and XRS models, trimming would be needed.
To see the installation details, click on the provided link.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Search Results: draw tite
- Shop: Trailer Hitch
- Shop: Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Q&A: Does Draw Tite Hitch part # 24812 Fit a 2003 Toyota Matrix XR
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommended Flat Towing Components For A 2024 Chevy Trax
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: How to Figure Out Which Reese Goose Box Fits Fifth Wheel Trailer
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: How to Tell the Difference Between a 4-Bolt and a 10-Bolt 5th Wheel Hitch Mounting Rail
- Article: Roadmaster Tow Bar Feature Descriptions
- Article: Trailer Hitch Receiver Sizes
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Q&A: Recommended Hitch for a 2024 Subaru Legacy
- Q&A: Which Way Do the Washers Install On the Curt Hitch C12228