Could Flexco Pull Out Step part # SMFP-3100 Mount to Wall Vertically
Question:
Hi, in regards to this SMFP-3100 May I mount it on a wall vertically? My loft is about less than 3 feet in height and I need to mount it on the wall to step from the bottom floor to the loft. Please advise,
asked by: Dennis B
0
Expert Reply:
While the Flexco Pull Out Step part # SMFP-3100 was intended to be mounted to the mouting flange on top of the step there's no reason you couldn't come up with a way to mount it vertically to the back side of the steps.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Flexco Manual Pull-Out Steps for RVs - Triple - 8" Drop/Rise - 24" Wide - 300 lbs
- RV Steps
- Towable Camper
- Pull-Out Step
- 24 Inch Wide Step
- 28-1/8 Inch Wide
- 3 Steps
- 8 Inch Drop/Rise
- No Ground Contact
- Steel
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Replacement Hub for Old Boat Trailer with 07100 Bearing
- Q&A: Correct Replacement for AL-KO 7230 Hub/Drum and Brakes
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Replacement Leaf Springs for Harbor Freight Folding Trailer
- Q&A: What Size Bolts To Install Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Q&A: Installation Instructions for Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Q&A: Can 2019 Nissan Rogue Be Towed Behind a Motorhome
- Article: Calculating Portable Generator Power Needs
- Article: How to Measure for Motorhome Steps
- Q&A: RV Step Recommendation that Can Fit 27 inch Wide Mounting Brackets
- Article: RV Propane 101: How Does My RV's Propane System Work?
- Article: Slipper Spring Trailer Suspension System Review
- Article: 7 Steps to Clean Your RV Awning, Prevent Mold, and Save Money