Are the Ends of the 5/8 Inch Steel Roller Shaft Part # CE10727A Tapered
Question:
I want to use 10 keel rollers and i noticed the shafts you have come in one sz. width13. I know i will have to cut the ends of the shaft but was wondering if the ends of these roller shafts are tapered??
asked by: Wesley C
0
Expert Reply:
The ends of the roller shaft, part # CE10727A, are not tapered. The shaft is 5/8 of an inch in diameter from end to end.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Roller Shaft with Pal Nuts for Boat Trailer Rollers - Zinc-Plated Steel - 13" x 5/8"
- Boat Trailer Parts
- Rollers
- Roller Shafts
- 5/8 Inch Diameter
- Zinc-Plated Steel
- 13 Inch Long
- CE Smith
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: How to Wire a 6 Pole Round Trailer End Plug
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Recommended Replacement Grease Seal and Braking Assemblies for an AL-KO 7210
- Q&A: Where is the Factory Trailer Brake Controller Port On a 2022 Chevrolet Tahoe
- Q&A: Where Is Factory Trailer Brake Controller Port On 2021 Chevrolet Tahoe W/ Factory Tow Package?
- Q&A: Trouble Finding the Brake Controller Wiring Port on a 2019 Chevy Blazer
- Q&A: What is the Widest Keel Roller for a Boat Trailer
- Q&A: How Does Brake Controller Install on Freightliner S2RV Chassis
- Article: Trailer Lighting Requirements
- Article: Replacement Automotive Lighting
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 7 Common Questions Everyone Has About Trailer Tires