Recommended Front Mounted Trailer Hitch for 2018 Thor Freedom Elite on 2017 Ford E-350 Chassis
Question:
I purchased ft mount receiver #65053. There is a reference for an 8mm wrench. What is that for? and in the instructions, step #3 says to enlarge forward hole on vehicle with half inch drill bit. I have to drill out all 4 holes correct? and lastly, does the bumper have to come off, or do I leave it hanging a little?
asked by: Paul
Helpful Expert Reply:
The Draw-Tite Front Mount Trailer Hitch Receiver # 65053 is a confirmed fit for your 2017 Ford E-350 Chassis. The hitch has a trailer weight capacity of 5,000 lbs so you will have no issues with your trailer weight. I recommend using the same ball mount you use to pull the trailer to make it easy. A front mounted hitch does make maneuvering a trailer much easier, so this will be a good solution for you.
Product Page this Question was Asked From
Draw-Tite Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Custom Fit Hitch
- Front Mount Hitch
- 500 lbs Vert Load
- 9000 lbs Line Pull
- 2 Inch Hitch
- Square Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Front Hitch that Fits 2022 Ford E-450 Motorhome
- Q&A: Is There a Bumper Mounted Bike Rack Capable of Carrying a Honda Trail 125 Behind a Class C Motorhome
- Q&A: Front Mount Hitch for a 2014 Ford E-450 RV Cutaway
- Q&A: Does Draw Tite Front Hitch # 65053 Fit 2019 Ford E450 Class C RV
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Torque Ratings for Front Anti-Sway Bar on 2019 Ford E-Series Van Cutaway Chassis
- Q&A: Front Hitch Recommendation for 2017 Thor Motorhome Built on E-450 Chassis
- Q&A: Hitch Recommendation for a Ford E-450 Bus
- Article: Determining Trailer Tongue Weight
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Article: Stability Control for Heavy Duty Vehicles
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: How to Measure for Trailer Hitch Drop
Paul
3/8/2018
I purchased ft mount receiver #65053. There is a reference for an 8mm wrench. What is that for? and in the instructions, step #3 says to enlarge forward hole on vehicle with half inch drill bit. I have to drill out all 4 holes correct? and lastly, does the bumper have to come off, or do I leave it hanging a little?