Replacement Motor Recommendation for Lippert Electric Stabilizer Jacks
Question:
My rear Lippert stabilizer jack will extend down but wont retract back up. as soon as retract is pushed the auto resetting fuse trips. Does same thing with the motor disengaged from jack. Switched the front auto reset fuse with the rear and did same thing. Changed the switch and does same thing. Can I assume the motor is bad at this point?
asked by: Mark W
1
Helpful Expert Reply:
Sounds like the motor is bad and you'd need to replace it with the C-800 Replacement Klauber Motor part # LC138445.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
C-800 Replacement Klauber Motor for Standard Lippert Electric Stabilizer Jacks
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Motor
- Lippert
more information >
Continue Researching
- Q&A: Correct Gen-Y Pin Box to Replace a MORryde RPB72-1716
- Q&A: Replacement Stabilizer Jack Need for Lippert Model 113407
- Q&A: Replacement Motor for LCI Power Stabilizer Jack Model 1917771
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Most Popular Wheel Bearings
- Q&A: Recommended Replacement for Atwood GC10A-4E RV Water Heater
- Q&A: Solution for Keeping RV Furrion Refrigerator Doors Closed when Travelling
- Q&A: Replacement Motor for Lippert Components PSX2 Electric RV Stabilizers
- Q&A: Reese Goose Box Recommendation to Replace MORryde Pin Box SPB72-1621LD
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Bleed Your Trailer Surge Brakes
- Article: How to Measure a Trailer Axle
- Article: RV Cell Boosters, How Do They Work?