Wiring Adapter with P3 Controller for 2002 F150 Supercrew

Question:

Hello - I am interested in purchasing a Tekshona P3 trailer brake controller. I have a 2002 F150 supercrew with a factory tow package. I dont see a plug listed that works with my truck. I do have a plug under the dash where I think the controller should plug into. Thanks

asked by: Geoff N

Helpful Expert Reply:

For most applications, the factory plug is located beneath the dash, near the center console. To install your electric brake controller # 90195 you need to connect the wiring of the controller to your vehicle. Certain manufacturers offer pre-wired options, typically known as tow packages, wherein these wires are run for you from the dash to the trailer connector on the back of your vehicle. Often, a brake controller wiring harness is included with your tow package. This harness plugs into a port beneath your dash and connects to the four wires of the brake controller. If, however, you have a brake controller with a plug in place of the four loose wires, you can use the Tekonsha adapter # 3035-P.

This adapter requires no hardwiring. It is designed to plug directly into your electric brake controller for the simplest installation possible. Because there are no wires to connect, installation is not permanent. You can unplug and remove your brake controller at any time and securely stow it away.

If your Ford does not have a 7-way connection you will need # 118242 to complete your wiring.

I have install videos attached to make this process simpler.

expert reply by: Timothy G