Should I Get the Hydroflush with a 45 or 90 Degree Bend
Question:
Do you recommend the 45 or 90 degree bend Hydroflush?
asked by: Homer
Expert Reply:
The 45 degree, part # F02-4100, and the 90 degree, part # F02-4110, Hydroflush Reverse Flush Adapters are the same product other than the bend in the line. Which is beter for you depends on your specific application.
Most people seem to prefer the 45 degree angle works better for them because of where the waste valve is located on their RV. For some the waste valve is very low and close to the ground so the 90 degree makes it easier.
Products Referenced in This Question
Valterra Hydroflush Reverse Flush Adapter for RV Holding Tanks and Sewer Hoses - 90-Degree
- RV Waste Valves
- Flush Valves
- Stationary Valve
- Valterra
more information >
Product Page this Question was Asked From
Valterra Hydroflush Reverse Flush Adapter for RV Holding Tanks and Sewer Hoses - 45-Degree
- RV Waste Valves
- Flush Valves
- Stationary Valve
- Valterra
more information >
Continue Researching
- Q&A: Trunk Bike Rack Recommendation for 2018 Kia Sorento with Spoiler
- Q&A: What is Considered a Backer For 12 Foot 7 Inch Solera RV Slide-Out Awning LCV000165061
- Article: How to Install an RV Awning From Scratch
- Q&A: Correct Backup Camera for Forest River Rockwood Mini Lite Travel Trailer
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps
- Q&A: Dimensions of SolidStep Locking RV Storage Box
- Q&A: Recommendations For Replacing RV Water System Components
- Article: How Much Solar Power Do I Need For My RV?
- Q&A: Can Torklift Lithium Battery Box # TLA7700L be Used on Non-Lithium Batteries
- Q&A: Battery Box Options for Dual Group 31 Batteries
- Article: Types of Bumpers
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller Installation: Starting from Scratch